Vizualogic Computer Monitor VL8000 Series User Manual

Visor Installation

1. Disconnect the vehicle’s negative battery terminal. (Black wire)

2. Please see Visor Removal Instructions to remove the passenger side visor.

3. Remove the ‘A’ pillar trim and kick panel on the passenger side and route the Video

Cable and Ground Wire around the front edge of the headliner and across to the ‘A’.

4. Install the visor monitor and mounting brackets to the headliner by reversing the Visor

Removal Instructions.

5. Route the Video Cable and Ground Wire down the ‘A’ pillar. Use a wire fish to pull the

cable straight down past the edge of the vehicle’s dash to the kick panel.

6. From behind the kick panel, route the Ground Wire, under the front edge of the carpet,

across the vehicle to the Parking Brake. Use the supplied connector to attach the Ground

Wire to the vehicle wire for the Parking Brake Switch.

7. Continue routing the Video Cable under the door sill and carpet and

connect the video control box.

Vizualogic^®Visor System Diagram

VL8000 Series

Hummer H2

VISOR MONITOR SYSTEM

Corona, CA U.S.A.

Installation Manual

060300

1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax 909-272-1584

Fall 2003

99-8014-002 10/03